User`s guide

Establishing Communications
Set Up Communications Link
Release E UMC800 Control Builder User’s Guide 29
1/01
Step Action Graphic/Result
4 Modbus RTU
If you select SERIAL
• Select the Communications Port. The Baud
Rate of 19200 is automatically selected.
• Enter the Instrument address in the active
field.
If you select Ethernet
• Enter the Instrument Modbus address in the
active field.
• Enter the IP Address configured for the
Ethernet Bridge Module on the instrument in
the active field.
5
Then click on “ADVANCED”.
Caution:
It is not recommended that you set the
values lower than those shown in the
dialog box, since it may cause some
communications operations to fail.
Press this button to reset these fields.
6
Refer to Table 10 for a list of available Communications parameters and selections, make the entries in
the active fields of each dialog box, then press OK.