User`s guide

Appendix C - Alarm Configuration Overview
Assigning Alarms to Alarm Group Displays
Release E UMC800 Control Builder User’s Guide 257
1/01
Assigning Alarms to Alarm Group Displays
Introduction
After the alarms have been configured, you can assign the alarms to Alarm group displays. Figure 71 is an
overview of how this is accomplished. For specific instructions about assigning alarms to alarm group
displays, refer to Alarm display tag group (page 101).
Select “Display
Tag Groups”
from the
Configure menu.
Select the “Alarm”
Tab for
configuration.
Figure 71 Assigning alarms to group displays