User`s guide

Appendix B - Loop Application Examples
Setpoint Programmer Examples
Release E UMC800 Control Builder User’s Guide 249
1/01
Example 2 - PID with setpoint programmer and event outputs
The SP programmer event output status may be directed to
digital outputs, part of control logic, or be directed to signal
tags for use anywhere within the control configuration.
Example 3 - Alternate methods for actuating SP programmer START/HOLD/RESET functions
Two methods are shown
The pushbutton block will tie this function to the
Pushbutton screen display. Pushbuttons will
provide a one-shot output each time they are
pressed.
Using the Digital variable block this function can
be displayed on the OVERVIEW display.
Note: Since Digital variables are turned ON and
OFF from the overview display, once turned ON
they must be manually turned OFF, to be used a
second time.
Note: Control Builder Software will not allow
the output of two block to be tied together.
Connections are shown for DEMO only of an
alternative connection.
FAIL