User`s guide

Uploading a Database from the Controller
Uploading the Database
220 UMC800 Control Builder User’s Guide Release E
1/01
Step Action Graphic/Result
2
From the “Communications” menu, select “Upload”.
The “Upload File” dialog box will appear.
It will state the file name and path.
It will state the “Status” as READY.
3
Click “START”.
A message box may open and advise that if the controller is
in the RUN mode, changes made during upload may not be
captured. Click “OK”.
The “Status” will report the current action
and will show a “Percentage Complete”
in that field.
When the upload is complete the “Status”
will show “Upload Complete”.
4
Click “Close”. The database will appear in the active
window.
5
Select “SAVE” from the “FILE” menu. The “SAVE AS”
dialog box will appear.
• Click on a file name or assign a new file name to the file
in the “File Name” field.
• Click “SAVE”.
If there is a problem with the upload, a failure message will appear. Check your comm Set Up for correct
settings. NOTE: If the Control Builder uploads or downloads while the Operator Interface is doing one or
the other, the following error message will appear:
BAD SEQUENCE NUMBER