User`s guide

Data Storage Configuration
Data Storage Configuration
192 UMC800 Control Builder User’s Guide Release E
1/01
Data Storage Configuration
Introduction
The data to be collected, along with storage rates and start/stop controls are contained in a data storage file
that is loaded through the controller configuration serial port or through the disk drive of the operator
Interface. Data storage parameters may be defined using the Control Builder Configuration Software or
through a separate User Utility Software program for a PC. Storage parameters may not be established
through the operator interface, thereby simplifying operator actions and reducing the potential for
accidental entry errors.
Accessing the data storage configuration tabs
Follow the procedure in Figure 55 to access the “Data Storage Configuration” dialog box.
Select “Data Storage”
from the “Configure”
menu.
Select a Tab for
Configuration
Trend
Point Log
Alarm/Event
The “Data Storage
Configurations” dialog
box will appear.
Figure 55 Accessing the data storage configuration dialog box