User`s guide

Controller Recipes
Recipe Configuration
180 UMC800 Control Builder User’s Guide Release E
1/01
Setup/edit recipe
The “Edit Recipes” dialog box lets you set up or edit a recipe listed in the “Recipe Pool.”
Table 46 Recipe setup/edit
• Make sure you have clicked on “Properties” and have
given that specific recipe a name. See Recipe pool
(page 179) before proceeding.
• Click on a recipe name in the active field and select
“Edit Program” or double click on the recipe name.
The “Edit Recipe” dialog box will appear. It looks like
this graphically on the Control Builder.
• To ADD Variable to a Recipe:
Select a variable and click on ADD. A variable
number will appear under “Recipe Items” as shown in
the figure.
• To DELETE a Variable from a Recipe:
Select a variable number from the “Recipe Items”
field, then click “Delete Item”.
• From the “Recipe Item Edit” list, select a variable
name from the list of variables and click on “ADD”.
• If it is an analog variable, the “Analog Value” field
will become active. Enter a value and press
“ENTER” on the keyboard.
• If it is a digital variable, the “Digital State” radio
buttons become active. Select ON or OFF as a digital
state for the variable. You can assign a label to the
variable when you are adding a variable to the
Function Block diagram and the label name will
appear next to the radio buttons.