User`s guide

Controller Recipes
Recipe Configuration
178 UMC800 Control Builder User’s Guide Release E
1/01
Recipe Configuration
Overview
Introduction
Each recipe consists of 1 to 50 Variables, and carries its own unique recipe number and name for
identification. (The names are descriptive references [aliases] and uniqueness is not enforced. Unique
names are recommended to avoid operator confusion.) The selected Operator Variables were assigned
during the Function Block Diagram Configuration.
It is possible to edit the setting of any recipe Variables through the Recipe Setup display at the operator
interface. This means that an operator can adjust individual ingredient amounts in the recipe; but the
ingredients (item’s Variable Name), the order of the ingredients, and the recipe’s number and name are
under configuration control.
Configuration functions
There are three basic functions that you will use to configure a Recipe.
• Recipe Pool
The Recipe Pool lets you add or delete a recipe on a list of configured recipes. Through this dialog box
you will set the properties for each recipe and set up or edit the information for each recipe.
• Recipe Properties
The Recipe Properties is merely a name to be assigned to the recipe, which will be added to the pool.
• Recipe Setup (EDIT)
Recipe Setup or Edit consists of selecting variable names, assigning an analog value or digital state, and
adding them to a list of Recipe items.