User`s guide

Setpoint Scheduler
Setup/Edit Setpoint Schedule
172 UMC800 Control Builder User’s Guide Release E
1/01
Edit the schedule segments
For each segment selected in the “Setpoint Schedule Edit” dialog box, an “Edit Schedule Segment” dialog
box will appear when you click on the “Edit” button. The segment number is shown at the top.
Each segment of the Setpoint Scheduler allows entry of a next segment recycle location and a number of
recycles up to 998, or infinite. This function allows unlimited recycle nesting and continuous recycle
operation. A jog function (Table 41) allows a single jump to a designated segment number through a
digital input to the State Switch block.
Figure 48 is an example of a Setpoint Schedule Segment dialog box. Refer to Table 43 and enter the
Segment information in the appropriate fields, the click “OK”. The LCB will return you to the “Setpoint
Schedule Edit” dialog box.
Refer to Edit the Aux Out values (page 174) for Edit Auxiliary Output Data Entry information.
Figure 48 Typical setpoint schedule segment edit dialog box