User`s guide

Setpoint Scheduler
Setpoint Schedule Configuration
170 UMC800 Control Builder User’s Guide Release E
1/01
Setpoint schedule properties
Introduction
This function lets you set the properties for the schedule selected in the Setpoint Schedule Pool. If you are
adding a schedule, this dialog box will automatically appear. It will also appear if you click on the
“Properties” button. The Label and Engineering Units will indicate the selections made when you
configured the Setpoint Schedule Displays [refer to Setpoint Scheduler Display Configuration (page
119)].
The information configured here will appear in the “Edit Schedule Segment” dialog box.
Dialog box structure
Figure 47 is an example of a Setpoint Schedule Properties dialog box. Refer to Table 41 and enter the
properties information in the appropriate fields, then click “OK”. The LCB will return you to the “Setpoint
Schedule Pool” dialog box.
Figure 47 Setpoint schedule properties dialog box
Table 41 Setpoint schedule properties
Parameter Parameter Description Entry Information
General
Label
Schedule Name 6 characters
Jog Seg
Logic input (JOG) on state switch block will cause the
schedule to jump to the start of the segment
designated then continue.
Segment number jog
will go to
Time Units
This selection assigns the time units (hours or
minutes) for all segments.
Hours
Time unit in Hours Click on Radio button
Minutes
Time unit in Minutes Click on Radio button
Guaranteed Hold Limit
The schedule will hold if a PV deviates above or
below (or both) the Setpoint value set here.
Select Guaranteed Hold Type on the “Setpoint Edit
Schedule” dialog box.
Enter a setpoint value