User`s guide

Release E UMC800 Control Builder User’s Guide 165

1/01

Setpoint Scheduler

Overview

Introduction

The objective of the Setpoint scheduler is to provide a sequence of multiple setpoint outputs (both analog

and digital) which are referenced to a common time base.

A suite of Setpoint Scheduler blocks is comprised of one Master Setpoint Block (required) and optionally,

one Digital Event, one Auxiliary Setpoint, one State Switch, and/or one State Flags block.

The Master block supports up to 8 ramp or soak outputs operating on a common time base. It accepts one

PV for each setpoint. Setpoint guarantee

is provided for the setpoints with a single symmetrical value for

each setpoint output. See Figure 46.

What’s in this section?

The following topics are covered in this section.

Topic See Page

Overview 165

What is a Setpoint Schedule 166

Setpoint Schedule Configuration

Overview

Setpoint schedule pool

Setpoint schedule properties

168

169

170

Setup/Edit Setpoint Schedule

Editing a schedule

Edit the schedule segments

Edit the Aux Out values

171

172

174