User`s guide

Setpoint Programming
Saving a Setpoint Profile
164 UMC800 Control Builder User’s Guide Release E
1/01
•
Select which events you want to turn ON or OFF at
the beginning of each segment. Segment events are
digital switches that provide ON/OFF output through
an SPEV function block in the Control Builder.
When a segment event is turned ON, it remains on
until the end of the segment at which time it is turned
OFF unless it is configured to turn ON in the next
segment.
Note that segment events are not interrupted by soak
time delays when the PV is outside the guaranteed
soak band. Events turn on as soon as the previous
segment is completed even if the PV has not reached
the soak setpoint.
After all the selections and entries are made for the
segment:
• Click on .
The information configured for the segment will be
reflected in the “Profile Segment Setup” field.
ATTENTION: If you are setting up the profile for the first
time, repeat the procedure for all segments in the
program.
If you want to edit a particular segment, click on the
segment number and edit the segment information in
the “Data Entry Area”.
• Click to return to the “Setpoint
Profile Pool” dialog box.
Saving a Setpoint Profile
Since Setpoint Program Configuration is a part of creating a Function Block Diagram, this information will
be saved when you complete the Function Block Diagram Configuration and save it. [Refer to How to
Save a Function Block Diagram (page 140).]