User`s guide

Setpoint Programming
Setup/Edit Setpoint Profile
162 UMC800 Control Builder User’s Guide Release E
1/01
Profile setup/edit procedure
Introduction
The Profile Setup/Edit Procedure consists of building a ramp/soak profile by:
• adding or inserting segments to a list of segment
• selecting the type of segment—Ramp or Soak
• selecting Guaranteed Soak for soak segments, if desired
• entering the value for the ramp or soak
• entering the value of the time or rate for the segment
• selecting an Aux. Out value (if required) for the segment
• selecting the events you want turned on or off at the beginning of the segment
• applying these selections to the segment
• repeating the procedure for all the segments in the program
Follow the procedure in Table 40 to configure the profile.
Table 40 Profile setup/edit configuration
• To ADD a Segment
Click on ADD. If it is the first segment, all the fields in
the “Profile Data Entry Area” will become active. The
default is a ramp.
• To INSERT a Segment
Click on the Ramp/Soak number in the field and click
“Insert”. A segment will be inserted after the segment
selected. This will change all the segment numbers
following the insertion.
• To DELETE a Segment
Click on the Ramp/Soak number in the field and click
“Delete”. The segment will be deleted and all the
segment numbers following the deletion will be
changed.
• Select (click on) a segment number and configure the
segment information in data entry area.