User`s guide

Setpoint Programming
Setup/Edit Setpoint Profile
Release E UMC800 Control Builder User’s Guide 161
1/01
The three main areas on the “Edit Setpoint Profile” dialog box are:
Properties Information Block
This block of information was developed during
“Properties” configuration. It lists the selection and
values that were made on the “Setpoint Profile
Properties” tab cards. These fields are read only; they
are for reference only. If you want to edit these
properties, refer to Setpoint profile properties (page
153).
Profile Data Entry area
This data entry area lets you make selections and enter
values for each specific segment in the Profile Segment
Setup Field. Click “Apply” to enter these choices to the
segment, which is highlighted in the segment set up
field shown below.
Profile Segment Setup Field
You can add, insert, or delete segments in your
program.