User`s guide

Setpoint Programming
Setup/Edit Setpoint Profile
160 UMC800 Control Builder User’s Guide Release E
1/01
Setup/Edit Setpoint Profile
Introduction
The “Edit Setpoint Profile” dialog box lets you set up or edit a profile for the programs listed in the
“Setpoint Profile Pool”.
Table 39 Setpoint profile setup/edit
• Make sure you have clicked on “Properties” and have
configured the properties for that specific program.
See Setpoint profile properties (page 153) before
proceeding.
• Click on a profile name in the active field and select
“Edit Program” or double click on the profile name.
The “Edit Setpoint Profile” dialog box will appear. It
looks like this graphically on the Control Builder. It
contains the following Segment attributes:
• Segment Type (Ramp or Soak)
• Guaranteed Soak enable (yes/no)
• Value
• Time/Rate
• Aux. Out Value
• Event Selection (1 through 16)