User`s guide

Setpoint Programming
Setpoint Profile Configuration
Release E UMC800 Control Builder User’s Guide 153
1/01
Setpoint profile properties
Introduction
This function lets you set the properties for the program selected in the Setpoint Profile Pool. If you are
adding a program, this dialog box will automatically appear. The information configured here will appear
in the “Edit SP Profile” dialog box.
Dialog box structure
The SPP Profile Properties dialog box is divided into five tab cards, each containing specific properties
information.
Tab Card Properties Information
TEXT
Label, Engineering Units, Aux. Out Description, Aux Out EU Label
GENERAL
Ramp Type (time or rate). Guaranteed Hold Type, Time units,
Guaranteed Hold Hi/Lo.
LOOP/JOG
Jog segment, Loop start segment, Loop end segment, Repeats
START/RESTART
Restart Rate
DISPLAY
Display High Limit, Display Low Limit
• Click on the tab to access the properties for that tab.
• Enter the information required for each tab then click “OK”.
• Click on the profile name in the Setpoint Profile Pool and select “Edit Program” to set up the Profile. See
Profile setup/edit procedure (page 162).