User`s guide

Setpoint Programming
Setpoint Profile Configuration
152 UMC800 Control Builder User’s Guide Release E
1/01
Setpoint profile pool
Introduction
The SP Profile Pool lets you add or delete a profile on a list of configured profiles. Through this dialog box
you will set the properties for each profile and set up or edit the information for each segment that make up
a profile.
When you select “Setpoint Profiles” from the Configure
menu, the “Setpoint Profile Pool” dialog box will be
displayed. Through this display, you will add a new
profile or delete an existing one and also enter the set
properties function and the “Edit Program” function to
set up each profile.
• To ADD a Profile:
Select ADD on the dialog box. The “Setpoint Profile
Properties” dialog box will open.
See Setpoint profile properties (page 153) for
instructions.
• To EDIT a Profile:
Select a profile then click on “Edit Program”. The
“Edit Setpoint Profile” dialog box will appear.
See Profile setup/edit procedure (page 162) for
instructions.
• To EDIT the Properties of an Existing Profile:
Select a profile name then click on “Properties”. The
“Setpoint Profile Properties” dialog box will open.
See Profile setup/edit procedure (page 162) for
instructions.
• To DELETE a Program:
Click on a profile name and then click “Delete”.