User`s guide

Setpoint Programming
Setpoint Profile Configuration
Release E UMC800 Control Builder User’s Guide 151
1/01
Setpoint Profile Configuration
Overview
Introduction
Setpoint Program (Profile) configuration provides a quick and easy way to create, edit, and save up to 70
different ramp/soak (setpoint) profiles for the Setpoint Programmer (SPP) control blocks in the
configuration. An operator can interact with the configured profiles through the Setpoint Program Operate
display at the operator interface or operation can be directed through integral actions connected by
Softwiring functions in the Control Builder.
Configuration functions
There are three basic functions that you will use to configure a Setpoint Profile.
• Setpoint Profile Pool
The SP Profile Pool lets you add or delete a profile on a list of configured profiles. Through this dialog
box you will set the properties for each profile and set up or edit the information for each segment that
make up a profile.
• Setpoint Profile Properties
Setpoint Profile Properties is information for the profile that is entered on five specific tabs. It includes
Text, General, Loop/Jog, Start/Restart, and Display.
• Setpoint Profile Setup (EDIT)
Setpoint Profile Setup or Edit consists of configuring each segment of the profile and assigning the
ramps and soaks in the order required to complete your SP program.