User`s guide
Control Strategy Configuration
How to Configure Start Up Conditions for Controller Initialization
Release E UMC800 Control Builder User’s Guide 125
1/01
Overview displays for read/write actions setup
The Overview displays may have a combination of up to 12 Signal Tags (for monitoring or read-only) and
Analog or Digital Variables on each display (up to 20 displays can be configured), in any combination.
The assignment of Variables to these screens allows the operator to directly enter on-line changes for the
analog Variables or selection of an ON or OFF status for Digital Variables.
These overview displays allow the user to customize the operator interface for monitoring only, or for
operator entries. They may also supplement the push button screens for digital actions although an ON or
OFF selection is continuous, not momentary. For example:
• Recipe variables may be listed (changed on-line at this display for the current process only or with
security applied) and can be loaded through recipe selection [via the Recipe display assigned to one of
the Display Buttons (1-8)] but shown on an Overview display
• A list of only alarm setpoints may be created
• An operator parameter entry display for biases, auxiliary setpoints or controller setpoints, etc. may be set
up as a list
• A series of process on-off digital actions, such as turning on auxiliary pumps or heaters, may be on one
screen, etc.
Any of the above may be combined with read-only Signal Tags (analog or digital values) on the display.
For the setup of the Overview display, refer to Overview display tag groups (page 109).
How to Configure Start Up Conditions for Controller Initialization
See Appendix D – Controller Initialization for a description of default conditions for Variables, function
block outputs, recipes, profiles after a configuration download. This section describes methods of
automatically loading values into analog or digital Variables plus an example of creating a momentary one-
shot digital status after a download.