User`s guide

Control Strategy Configuration
Operator Pushbutton/Selector Switch/Data Entries Configuration
Release E UMC800 Control Builder User’s Guide 123
1/01
Operator Pushbutton/Selector Switch/Data Entries Configuration
Introduction
There are two types of displays that may be used for operator actions to replace panel pushbuttons or
selector switches:
• the single action Push button switch display, and
• the Four Selector switch display.
Each have corresponding function blocks for setup and interface to other blocks for creating the proper
action.
Pushbutton switch display setup
Each Pushbutton display has 4 momentary (one-shot) pushbutton actions that can be applied to the F1
through F4 operator interface keys and each has the option for switch confirmation through an external
input or internal status.
You can use up to 4 of these display types for a total of 16 pushbutton actions to replace or augment normal
panel pushbuttons and confirming status lamps or indicators.
The single action Pushbutton switch display is for applications such as turning on/off pumps, aux heaters,
or bypass solenoids, starting/stopping a particular process cycle or phase, selecting atmosphere, selecting
an override condition, an auto/manual process action, etc.
The setup of the Pushbutton display is associated with the Pushbutton function block and is not part of the
Configure menu. Please refer to the Control Builder Function Block Reference Guide (51-52-25-64) for
the procedure and examples of use.
F4
F3
F2
F1
Pushbutton Function Group Screen
FUNCTION DESCRIP
TAG45678
STATE1
FUNCTION DESCRIP
TAG45678
1234567
FUNCTION DESCRIP
TAG45678
STATE1
FUNCTION DESCRIP
TAG45678
STATE1
PUSHBUTTON TITLE
Pushbutton Function Block
Figure 35 Pushbutton function block and group screen
Figure 36 Pushbutton function block diagram example