User`s guide

Control Strategy Configuration
How to Configure Function Block Parameters
Release E UMC800 Control Builder User’s Guide 95
1/01
How to Configure Function Block Parameters
Introduction
After function blocks are placed on the Function Block Diagram, they can be configured.
To configure a block on the Function Block Diagram, double click on it to open its property dialog box
which contains parameters of the block.
• Most dialog boxes are simple dialog boxes
that contain the assigned block number
and execution order of the block.
To change the function block execution
order, refer to How to Configure the
Execution Order of the Block (page 98).
• Some dialog boxes contain various
parameters and options that are configured
based on the particular type of the function
block.
• For example; Module and Channel
addresses and Function Block
configuration parameters.
The figure to the right is an example of an
Analog Output Dialog Box.
• Tabbed dialog boxes will be used for the
most complicated blocks to organize the
data for you. The figure to the right shows
an example of a PID function block dialog
box.