User`s guide

Control Strategy Configuration
Connecting/Disconnecting Function Blocks (Softwiring)
92 UMC800 Control Builder User’s Guide Release E
1/01
Repositioning
To reposition an existing wire:
• Click on the end point of the wire to be
repositioned. It will be highlighted in a dotted line
showing each vertex.
• Click on a vertex and drag into the new position
and release.
TIP
A single “L” shaped wire cannot be repositioned. If you must alter the routing, delete the wire
and add one with a vertex.
Disconnecting an existing wire
Step Action
1
Click on the end point of the wire to be deleted. The wire is highlighted.
2
Right-click on the item and select “Delete” from the menu, pull down the “EDIT” menu and
select “Delete”, or press the DELETE key.