User`s manual

BL4S100 User’s Manual 36
4.2 Sample Programs
Sample programs are provided in the Dynamic C Samples folder. The sample program
PONG.C demonstrates the output to the STDIO window.
The various directories in the Samples folder contain specific sample programs that illus-
trate the use of the corresponding Dynamic C libraries.
The SAMPLES\BL4S1xx folder provides sample programs specific to the BL4S100. Each
sample program has comments that describe the purpose and function of the program. Fol-
low the instructions at the beginning of the sample program.
To run a sample program, open it with the File menu (if it is not still open), then compile
and run it by pressing F9. The BL4S100 must be in Program mode (see Section 3.5,
“USB Programming Cable,”) and must be connected to a PC using the programming cable
as described in Section 2.1, “BL4S100 Connections.” See Appendix C for information on
the power-supply connections to the Demonstration Board.
Complete information on Dynamic C is provided in the Dynamic C User’s Manual.
TCP/IP specific functions are described in the Dynamic C TCP/IP User’s Manual, which
is included in the online documentation set. Information on using the TCP/IP features and
sample programs is provided in Chapter 5, “Using the Ethernet TCP/IP Features.”
ZigBee specific functions are described in An Introduction to ZigBee, which is included
in the online documentation set. Information on using the TCP/IP features and sample pro-
grams is provided in Chapter 6, “Using the ZigBee Features.”