User`s guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message Details Action
MANUAL
<Paper Size>
The beeper sounds five times. Printer is
waiting for paper to be inserted in the
Multipurpose Feeder. The present job is
held until you press the Select key, or the
Manual Feed Wait time-out occurs.
Load appropriate paper as indicated and
press Select for each MANUAL message.
MULTI TRAY
EMPTY
The beeper sounds five times. All
communication channels are set to BUSY.
The present job is held until the paper is
loaded.
If you are using the Multipurpose Feeder,
install the correct paper size.
If you have changed the paper default to a
tray and are seeing this message, turn the
printer off (O), then on (l) to clear the
error.
NEED
CARTRIDGE
The beeper sounds five times. All
communication channels are set to BUSY.
Printing is halted until cartridge is
detected.
If the cartridge is present, ensure that it is
all the way into the cavity. If the cartridge
is missing, install a new one.
NO PAPER
TRAYS
The beeper sounds five times. All
communication channels are set to BUSY.
Printing is halted until the paper trays are
installed.
Install the paper trays.
PAPER
JAM>EXIT
The beeper sounds five times. All
communication channels are set to BUSY.
The error is written to the Error Log. The
present job is held until the jam is cleared.
Jammed pages are reprinted if Jam
Recovery is enabled (On).
Refer to "Clearing Paper Jams" in
Chapter 4. For transparencies, remove a
completed transparency from the output
tray before feeding a new one.
PAPER
JAM>FUSER
The beeper sounds five times. All
communication channels are set to BUSY.
The error is written to the Error Log. The
present job is held until the jam is cleared.
Jammed pages are reprinted.
Refer to "Clearing Paper Jams" in
Chapter 4. If you are using the
Multipurpose Feeder for transparencies
(or other special materials), ensure that
the stack is not above the inside tabs on
the adjustable feed guides. If jamming
continues, reduce the number of
transparencies or other material in the
feeder.
Diagnostics and Troubleshooting 5-7