User`s guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Appendix B
Power Cord Requirements
The power cord you received with your printer meets the
requirements of the country where you purchased the product.
If you use the printer in another country, you must use a power
cord that meets the requirements of that country. For more
information on power cord requirements, contact your
Authorized Digital Reseller or Service Provider.
The following information explains the requirements for power
cord selection.
General
Information
1. The cord must be approved for the country where it will
be used.
2. The appliance coupler (that is, the connector to the device
itself, not the wall plug) must have a configuration for
mating with an EN 60320/IEC 320 appliance inlet (Standard
Sheet C14).
3. The length of the cord set must be as follows:
Minimum 6.50 ft. (2.0 m)
Maximum 9.75 ft. (3.0 m)
U.S. and Canada 1. The cord must be UL-Listed and CSA-Certified.
2. The minimum specifications for the flexible cord are:
No. 18 AWG
Type SV or SJ
3-conductor
3. The cord must have a rated current capacity of at least
10 Amperes.
B-1