Troubleshooting guide

Technical Characteristics
C-6
Configuration Printout
The configuration printout can be used to show you the default settings
or if you have changed the configuration of the box, it will show you
the current configuration. The printout will show:
− Firmware revision level
− Dipswitch setting
− Software setting
− Digital ANSI protocol commands settings
To run the configuration printout, press the button once.
TM
CONFIGURATION SHEET
Revision Level V2.O
Dipswitch Settings
Baud Rate : Data bits : Parity : Buffer Control :
300 4800 7 bits Disable Busy / Ready
600 9600 8 bits Enable Odd Xon / XOff
1200 19200 Enable Even
2400 38400
Autowrap : Hexdump : Paper : PPL3/LN03plus : Autosensing/Trans. :
OFF OFF A4 PPL3 Autosensing mode
ON ON US LN03plus Tranparent mode
Setup
General
Target Printer LN17
Emulation Autosensing
Time Out / Input Serial Interface 100 seconds
Time Out / Ouput Parallel Interface 30 seconds
Input Buffer Size 5.0 Kbytes
Image Offset, Horizontal Value 0.0 Millimeters
Image Offset, Vertical Value 0.0 Millimeters
Horizontal Printing Protection ON
Vertical Printing Protection OFF
Font Printing Protection OFF
Device ID Default
Digital Ansi
Line Feed Mode LF = LF
Carriage Return Mode CR = CR
Character Set GO = US Ascii
G2 = DEC Supplemental
Number of Copies 1
1 2 3
4 5 6 7
98
1 2 3 4 5 6 7 8 9 10 11 12
ON
OFF
10
11 12
Configuration Printout