Troubleshooting guide

Factory Default Configurations
B-2
Software Configuration
Software configuration is performed using specific conversion box and
Digital ANSI protocol commands. They can override or dynamically
change the dipswitch settings. The factory default settings determined
by these commands are:
Specific Conversion Box Command - Factory Default Configuration
Features Value
Target Printer LN17
Emulation Autosensing (PPL3 / PostScript)
Time out on input serial port 20 seconds
Time out on output parallel
port
30 seconds
Image offset (horizontal) 0
Image offset (vertical) 0
Input buffer size 5 Kbytes
Horizontal Print Protection Not set
Vertical Print Protection Not set
Font Print Protection Not set
Device Identificator PPL3
Reset to Factory Default
The factory default configuration can be recovered by sending the
Specific conversion box command Reset «DCS 58 ; 1i (Reset) ST»
from the host.