Troubleshooting guide

Specific Conversion Box Commands
A-8
Printer
Command Syntax
Meaning
(= Printer/Model
3
#LN17)
Selects printer as LN17
1
(= Printer/Model
3
#DEC3500)
Selects printer as DEC3500
1
(= Printer/Model
3
#DEC5100)
Selects printer as DEC5100
1
(= Printer/Protection/Horizontal #ON)
Solves incorrect horizontal print
positioning
(= Printer/Protection/Vertical #ON)
Solves incorrect vertical print
positioning
(= Printer/Protection/Fonts #ON)
Avoids font deselection
(= Printer/Offset/Vertical numeric value)
Shifts the logical page down
vertically by a numeric value
2
(= Printer/Offset/Horizontal numeric value)
Shifts the logical page right
horizontally by a numeric value
2
(= Printer/Offset/Vertical/Negative numeric value)
Shifts the logical page up vertically
by a negative numeric value
2
(= Printer/Offset/Horizontal/Negative numeric value)
Shifts the logical page left
horizontally by a numeric value
Note:
1
Will map paper tray accordingly
2
numeric value is expressed in millimeters to 1 decimal point.
3
Model: Since the Convert Box detects which printer is connected
automatically, this attribute is used only when the connected printer is
unknown or when the Convert Box is unable to detect it.
Time out
Command Syntax Meaning
(= Timeout/Serial numeric value)
Set the time (in seconds) on the serial
input port before the box:
- Returns to Autosensing
- Perform an internal reset
The value should be always equal or
greater than the host time out.
(= Timeout/Parallel numeric value)
Set the time (in seconds) on the parallel
output port.
Used when change emulation.
The value should be always equal or
greater than the printer time out