Troubleshooting guide

Specific Conversion Box Commands
A-6
Commands List
The tables in this section show examples of the box specific commands
(command_n) and describes their meaning.
For simplification in the examples shown below, the Introducer DCS
(9OH) and String Terminator ST (9CH) sequences are not included. Do
not forget to insert them when sending the complete command.
Using the Reset Operator
The Reset operator recalls the factory default values for the Type family
parameter selected.
When Reset is used alone, all Type family parameters are reset to their
factory values, as well as all Digital commands.
Examples:
-(Reset)
-(Reset Emulation)
-(Reset Timeout)
Note: See Appendix B for factory default configuration setting.
Assigning a Condition Using the = Operator
The following tables give examples of how you can assign specific values
to the commands. They are categorized according to type family.
Buffer
Command Syntax Meaning
(= Buffer/Size numeric value)
Modifies the size of the input
buffer by assigning a numerical
value specified in Kbytes.
Decreasing the buffer size
allows you to support more
down line loaded fonts.
for example: (= Buffer/Size 7) Sets current input buffer to
7 Kbytes