Troubleshooting guide

Configuring and Operating
2-2
Dipswitch Configuration
The dipswitch settings control the main configuration parameters of the
box. The box is delivered with default settings that you might have to
change according to your host and printer parameters which you check
before installing the box.
The dipswitch enables you to set the following parameters on the box:
• Serial communications
• Autowrap
• Paper format
• Operating mode
- Autosensing/Transparent
- PPL3/LN03plus
- Hex Dump
The serial communication and the paper format setting are
mandatory.
The figure below shows the default settings for the dipswitch
(European version)
ON
123456789101112
ABCDEFGHI
Caution:Make sure the conversion box is powered down and
disconnected from the printer and the host. It is important to
also remove power from the printer. After you have
configured the box dipswitches, reconnect the box to the host
and printer. Power up the box first and then the printer.