Troubleshooting guide

2-1
ENGLISH
2
Configuring and Operating
Configuring the Conversion Box
If the default settings of the box and your host and printer do not
match, you will need to configure the box. You can do this primarily
through changing the dipswitch settings on the box (dipswitch
configuration). In addition to this, you can use control commands
issued from the host that can override or dynamically change the
dipswitch settings or set other parameters (software configuration).
Both these techniques are described in the following sections.
Configuration information is saved in memory, and is recovered after
each power up, or when the box is reset using the reset button. You can
print out the configuration information by running one of the internal
tests as described in Power On and Testing in Chapter 1.