Troubleshooting guide

Installing the Conversion Box
1-7
ENGLISH
Stage 2 - Connecting the Conversion Box
Provided that the pre-installation checks do not require any
configuration, you can now connect the pieces of equipment together
in the following sequence:
Note: Ensure that all equipment is switched off and the power cables
removed from the mains power outlet before you connect any
cables.
1. Connect the conversion box directly to the target printer parallel
connector, or via the flat ribbon cable. Close the spring clips on
both sides of the connector.
2. Connect the serial communication host cable into the conversion
box female MMJ6 connector. If your serial communication host
cable is ending with an MMJ6 male cable, connect it into the
MMJ6 connector on the Convert Box directly. If your serial
communication host cable is ending with a DB25 connector, you
may connect it to the Convert Box via two optional parts as
follows:
- BC16E-02 flat cable with MMJ6 connector
- H8571-C converter DB25 to MMJ6 connector
BC16E-02 DB25H8571-C
3. Connect the AC/DC adapter to the conversion box.
Note: At this stage, DO NOT connect the AC/DC adapter cable to the
main power outlet.