Troubleshooting guide

Installing the Conversion Box
1-3
ENGLISH
Installing the Conversion Box
The box is installed in three stages:
1. Pre-installation Checks
2. Connecting
3. Power on and Testing
In many instances there will be no need to configure the box and you
can simply connect the box, power on and go. However, it might be
necessary to configure the box as described in Chapter 2.
Stage 1 - Pre-installation Checklist
Before you begin the installation, you need to check several aspects of
the operation of the host computer and the target printer. The settings
of these two pieces of equipment must match the settings of the box if
everything is to work properly.
1. Check the serial communication parameters of the host.
They must match those of the conversion box.
For example, if you had an LN03PLUS printer connected to the
host, you can check the settings that currently exist by pressing
the T button on the rear of the printer. This causes the printer to
output a configuration sheet which you can compare with the
default settings of the box.
If the host settings do not match the default settings on the box,
then the box has to be configured as described in Chapter 2.