Specifications
Appendix A: Training, Tools, and Documentation
A-2
Review the User's Guide and Driver Manuals; pay particular attention to:
• Chapter 3: Printing and using different types of media
• Using the control panel
• Control panel messages
• Appendix E: Paper Specifications
• Differences between the PCL and PS drivers
Overall, know the User's Guide and drivers completely.
2. The next 1/2 day involves using and understanding the Field Service Manual (EK-D35PS-
SG).
A. Review Chapter 1:
Printer Specifications
(this should be a review of User's Manual)
B. Read Chapter 2:
Printer Technical Description
C.
Study Chapter 3:
Using the Control Panel
D.
Study Chapter 4:
Troubleshooting and General Procedures
E. Study Chapter 5:
Wiring Diagrams
(Skim if phone support.)
F. Understand completely Chapter 6
FRU Replacement Fault Isolation Procedures
(skim quickly if phone support)
G. Review Chapter 7:
Using the Diagnostic Tool
(only if FRU support)
H. Review Chapter 8
Illustrated Parts Breakdown
(and supported Digital FRU part
numbers)
I. Chapters 9 through 15:
Removal an Replacement Procedures
(Review briefly if
phone support.)
J. Read Appendix A
Training, Documentation, and Tools
(this self paced guide is
included in this section)
3. The next 1/2 day involves doing a limited or complete teardown of the DEClaser 3500
printer (depending on your level of support). Use Chapters 9 through 15
: Repair and
Replacement Procedures
as a guide. Also refer to Chapter 5:
Wiring Diagrams
and Chapter
8:
Illustrated Parts Breakdown.
A. Do not spend alot of time removing components of the Feed Assembly module;
remove it and inspect the components at least. Make sure you understand the
remaining portions of this feed unit though. (The whole unit is considered a
FRU.)
B. Be very careful with the remove and replace procedure of the front assembly,
taking time to identify each component, how it goes together, and the purpose or
functions of the interrelated components.
C. Only inspect the sensors and understand the remove and replace procedure
D. Understand the PCB's R and R and all interconnects
E. Do not remove the ROS completely, this involves the entire teardown of the
printer.