Specifications

Chapter 14: Removal and Replacement Procedures --- Electrical Modules
14-17
RRP 6.8 Fan
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove all of the covers.
3. Remove the Fuser Assembly (RRP 4.1).
4. Remove the controller (ESS). (RRP 6.2)
5. Remove the ESS enclosure (RRP 6.1).
6. Remove the Electronics Box Cover (RRP 6.3).
7. Disconnect P/J 18 from the MCU PWB.
8. Remove the two 30mm gold screws and washers securing the Fan to the Frame Base .
9. Remove the Fan.
Replacement
1. Align the Fan with the holes in the Frame Base.
NOTE: Install the Fan with the label facing out, so the air flows OUT of
the printer.
2. Reinstall the two 30mm gold screws and washers securing the Fan to the Frame Base.
3. Reconnect P/J 18 to the MCU PWB.
4. Reinstall the Interconnect PWB enclosure (with PWB).
5. Reinstall the controller (ESS).
6. Reinstall the Fuser Assembly.
7. Reinstall the covers.