Specifications

Chapter 14: Removal and Replacement Procedures --- Electrical Modules
14-9
RRP 6.4 Earth Plate Assembly
Removal
1. Open the Front Cover.
2. Remove all of the covers.
3. Remove the CRU.
4. Remove the Fuser Assembly (RRP 4.1).
5. Remove the controller (ESS). (RRP 6.2)
6. Remove the ESS enclosure (RRP 6.1).
7. Unplug the Exit Sensor.
8. Disconnect P/J CR and P/J DB from the HVPS.
9. Remove the Link Assembly (RRP 3.1).
10. Remove the two tapped 8mm gold screws securing the Earth Plate Assembly to the ROS
Assembly .
11. Remove the Earth Plate Assembly.
Replacement
1. Position the Earth Plate Assembly on the left side of the ROS Assembly.
2. Reinstall the two tapped 8mm gold screws securing the Earth Plate Assembly to the ROS
Assembly.
3. Reinstall the Link Assembly.
4. Reconnect P/J CR and P/J DB.
5. Plug in the Exit Sensor.
6. Reinstall the ESS enclosure.
7. Reinstall the controller (ESS).
8. Reinstall the Fuser Assembly.
9. Reinstall the CRU.
10. Reinstall all covers.