Specifications

Chapter 13: Removal and Replacement Procedures - Drive and Xerographic Modules
13-13
RRP 5.5 ROS Assembly Continued
Replacement
1. Align the ROS Assembly onto the Frame Base.
2. Reconnect P/J 112 and P/J 114 from the ROS Assembly, and P/J 113
from the SOS Assembly.
3. Reinstall the six tapped 10mm gold screws securing the ROS Assembly.
4. Reinstall the CRU Sensor PWB.
5. Reinstall the CRU Actuator Assembly.
6. Reinstall the Drive Assembly.
7. Reinstall the LVPS Assembly.
8. Reinstall the HVPS.
9. Reinstall the Electronics Box Base along with the MCU PWB
10. Reinstall the Front Transport Assembly, Lower Chute Assembly, and two
Gear Front Covers.
11. Reinstall the Cable Cap on the ROS Assembly.
12. Reinstall the Earth Plate Assembly.
13. Reinstall the Link Assembly.
14. Reinstall the Gear Double R.
15. Reinstall the Gear Double L.
16. Reinstall the black and green wires on the LVPS.
17. Reconnect all P/Js on the HVPS (P/J 111, P/J CR, P/J DB, P/J TR, and
P/J RTN).
18. Reconnect all P/Js on the MCU PWB (P/J 11 through P/J 20), plus P/J
21 if a Toner Sensor Assembly is installed.
19. Reinstall the Interconnect PWB enclosure (with PWB) and P/Js 31, 50,
and 51.
20. Reinstall the ESS enclosure.
21. Reinstall the controller.
22. Reinstall the Fuser Assembly.
23. Reinstall the covers.