Specifications

Chapter 13: Removal and Replacement Procedures - Drive and Xerographic Modules
13-3
RRP 5.1 Drive Assembly
Removal
1. Remove all of the covers except the Front Transport Assembly.
2. Open the Front Cover.
3. Remove the CRU.
4. Remove the Fuser Assembly (RRP 4.1).
5. Remove the controller (ESS) . (RRP 6.2)
6. Remove the ESS enclosure (RRP 6.1).
7. Remove the Interconnect PWB enclosure (with PWB) (RRP 6.3).
8. Disconnect P/J 14 on the MCU PWB.
9. Remove the following five screws securing the Drive Assembly to the
printer frame :
• One tapped 8mm silver screw at the top of Drive Assembly.
• Three tapped 87mm gold screws.
• One tapped 10mm gold screw at the bottom rear of the Drive
Assembly.
10. Remove the Drive Assembly.
Replacement
1. Align the Drive Assembly with the holes in the side of the frame.
2. Reinstall the five screws securing the Drive Assembly to the ROS
Assembly.
3. Reconnect P/J 14 on the MCU PWB.
4. Reinstall the Interconnect PWB enclosure (with PWB).
5. Reinstall the ESS enclosure.
6. Reinstall the controller.
7. Reinstall the Fuser Assembly.
8. Reinstall the covers.
9. Reinstall the CRU.