Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-19
RRP 4.9 Exit Sensor
Removal
1. Open the Rear Cover (RRP 1.1)
2. Remove all of the covers except the Front Transport Assembly.
3. Remove the Fuser Assembly (RRP 4.1).
4. Unplug P/J 119 from the Exit Sensor .
5. Use a screwdriver to pry open the clips holding the Exit Sensor to the
Electronics Cover.
6. Remove the Exit Sensor.
Replacement
1. Align the Exit Sensor with the slot in the Electronics Cover. Face P/J 119
to the left side of the printer.
2. Firmly press the Exit Sensor into the slot. It will snap into place.
3. Reconnect P/J 119.
4. Reinstall the Fuser Assembly.
5. Reinstall the covers.