Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-17
RRP 4.8 Exit Actuator
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove all of the covers except the Front Transport Assembly.
3. Remove the Fuser Assembly (RRP 4.1).
4. Remove the Pressure Roll (RRP 4.2).
5. Remove the Exit Chute (RRP 4.3).
6. Remove the Heater Rod (RRP 4.6).
7. Remove the Heat Roll (RRP 4.6).
8. Lift the Exit Actuator, along with the attached Exit Spring, and remove
both from the Fuser Assembly .
Replacement
1. Reinstall the Exit Spring onto the Actuator arm, securing one leg of the
Spring into the hole on the side of the Actuator.
2. Reinstall the Exit Actuator, along with the attached Exit Spring, in the slot
next to the Temperature Sensor Assembly on the Fuser Assembly
(Figure 1 insert).
NOTE: Make sure you position the free end of the Spring in the slot so it
provides spring–return action for the Actuator.
3. Reinstall the Heat Roll.
4. Reinstall the Heater Rod.
5. Reinstall the Exit Chute.
6. Reinstall the Pressure Roll.
7. Reinstall the Fuser Assembly.
8. Reinstall the covers.