Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-15
RRP 4.7 Heat Roll
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove all of the covers except the Front Transport Assembly.
3. Remove the Fuser Assembly (RRP 4.1).
4. Remove the Pressure Roll (RRP 4.2).
5. Remove the Exit Chute (RRP 4.3).
6. Remove the Heater Rod (RRP 4.6).
7. Remove the right Heat Roll Ring (
spring clip ), Gear Heat Roll ( drive
gear
), Heat Roll Bearing ( collar ), and Ground Plate on Heat Roll Bearing
L .
8. Remove the Heat Roll.
Replacement
1. Position the Heat Roll by sliding it through the Heater Roll Bearing R and
Heater Roll Bearing L.
2. Reinstall the right Heat Roll Ring (
spring clip ), Gear Heat Roll ( drive
gear
), Heat Roll Bearing ( collar ), and Ground Plate on Heat Roll Bearing
L.
3. Reinstall the Heater Rod.
4. Reinstall Exit Chute.
5. Reinstall the Pressure Roll.
6. Reinstall the Fuser Assembly.
7. Reinstall the covers.