Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-9
RRP 4.4 Exit Roll Assembly
Removal
1. Remove all of the covers except the Front Transport Assembly.
2. Remove the Fuser Assembly (RRP 4.1).
3. Remove the Pressure Roll (RRP 4.2).
4. Remove the Exit Chute (RRP 4.3).
5. Remove the two E–Rings at the ends of the Exit Roll Assembly .
6. Remove the Gear Exit located on the right end of the shaft.
7. Slide the Exit Roll shaft to the left and out of the Fuser Assembly.
Replacement
1. Insert the ends of the Exit Roll Assembly into the holes just above the
Exit Chute area.
2. Reinstall the Gear Exit onto the right end of the shaft.
3. Reinstall the two E–Rings at the ends of the Exit Roll Assembly.
4. Reinstall the Exit Chute.
5. Reinstall the Pressure Roll.
6. Reinstall the Fuser Assembly.
7. Reinstall the covers.