Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-5
RRP 4.2 Pressure Roll
Removal
1. Remove all of the covers except the Front Transport Assembly.
2. Remove the Fuser Assembly (RRP 4.1).
3. Remove the two tapped 8mm gold screws securing the Fuser Cover
Assembly to the Fuser Base .
4. Remove the Fuser Cover.
5. Unlatch the nip straps and remove the Pressure Roll.
NOTE: The pressure roll bearings and springs on the nip straps drop off
very easily. Do not lose them.
Replacement
1. Position the Pressure Roll on top of the Heat Roll.
2. Clamp the nip straps down onto the metal ends of the Pressure Roll.
NOTE: You may have to reposition the Pressure Roll for the nip straps to
engage.
3. Reinstall the Fuser Cover.
4. Reinstall the two tapped 8mm gold screws securing the Fuser Cover
Assembly to the Fuser Base.
5. Reinstall the Fuser Assembly.
6. Reinstall the covers.