Specifications

Chapter 12: Removal and Replacement Procedures --- Fuser and Paper Exit
12-3
RRP 4.1 Fuser Assembly
Removal
1. Open the Front Cover.
2. Remove the Rear Cover (RRP 1.1).
3. Remove the Top Cover Assembly (RRP 1.2).
4. Remove the Left Cover (RRP 1.3).
5. Remove the Right Cover (RRP 1.4).
6. Remove the three tapped 8mm gold screws securing the Fuser
Assembly to the top of the ROS Assembly.
7. Slowly pull up on the Assembly to unplug P/J101.
8. Remove the Fuser Assembly.
Replacement
1. Align the Fuser Assembly with the holes at the top of the ROS
Assembly, and with P/J 101 at the left end of Fuser Assembly.
NOTE: Make sure the Gear Exit on the right end of the Fuser Assembly
meshes with the Drive Assembly gear, and the Paper Exit Actuator
clears the Paper Exit Sensor.
2. Press the Fuser Assembly firmly into place.
3. Reinstall the three tapped 8mm gold screws securing the Fuser
Assembly to the top of the ROS Assembly.
4. Reinstall all of the covers.