Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-33
RRP 3.16 Bottom Plate Assembly
Removal
1. Open the Front Transport Assembly.
2. Remove the Inlet Chute Assembly (RRP 3.9).
3. Remove the Pick–Up Roll Assembly (RRP 3.12).
4. Hold the Bottom Plate Assembly firmly at both ends and pull up to remove .
Replacement
1. Align the plastic slots at the base of the Bottom Plate Assembly with the plastic tabs on the
Front Transport Assembly.
2. Position the MBF Sensor Actuator in the cutout in the center of the Bottom Plate Assembly.
3. Press firmly on the Bottom Plate Assembly. It will snap into place.
4. Position the springs on each end of the Lower Chute Assembly so they contact the alignment
bosses at each end of the Bottom Plate Assembly.
5. Reinstall the Pick–Up Roll Assembly.
6. Reinstall the Inlet Chute Assembly.