Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-31
RRP 3.15 MBF Sensor
Removal
1. Open the Front Transport Assembly.
2. Remove the Inlet Chute Assembly (RRP 3.9).
3. Remove the Pick–Up Roll Assembly (RRP 3.12).
4. Remove the MBF Sensor Assembly (RRP 3.14)
5. Use your fingers to slightly spread the two plastic latches holding the Sensor in place.
6. Remove the MBF Sensor from the MBF Sensor Assembly .
Replacement
1. Align the MBF Sensor with connector P121 facing left.
2. Press the MBF Sensor between the plastic latches on the MBF Sensor Assembly. It will snap
into place.
3. Reinstall the MBF Sensor Assembly.
4. Reinstall the Pick–Up Roll Assembly.
5. Reinstall the Inlet Chute Assembly.