Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-25
RRP 3.12 Pick–Up Roll Assembly
Removal
1. Open the Front Transport Assembly.
2. Remove the Inlet Chute Assembly (RRP 3.9).
3. Remove the two tapped 8mm gold screws securing the Pick–Up Roll Assembly to the Front
Transport Assembly .
NOTE: If the Lower Chute Assembly is in the way, close the Front Transport
Assembly slightly. Remove the screws while you press the Bottom Plate
Assembly away from you.
4. Remove the Pick–Up Roll Assembly.
Replacement
1. Align the Pick–Up Roll Assembly with the holes in the Front Transport Assembly. Install the
Assembly with the Spring Clutch on the right end of the shaft.
2. Reinstall the two tapped 8mm gold screws securing the Pick–Up Roll Assembly to the Front
Transport Assembly.
3. Reinstall the Inlet Chute Assembly.