Manualshelf

Specifications

ManualsBrandsDigital ManualsComputer equipmentDEClaser 3500
341342343344345346347348349350
Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-21
RRP 3.10 Registration Sensor
Removal
1. Open the Front Transport Assembly.
2. Remove the Inlet Chute Assembly (RRP 3.9).
3. Use your fingers to slightly spread the two plastic latches holding the Sensor in place .
4. Remove the Registration Sensor from the Inlet Chute Assembly.
Replacement
1. Install the Registration Sensor with connector P120 facing the left side of the Inlet Chute
Assembly.
2. Press the Registration Sensor between the plastic latches on the Inlet Chute Assembly. It will
snap into place.
3. Reinstall the Inlet Chute Assembly.