Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-15
RRP 3.7 BTR Assembly
Removal
1. Open the Front Transport Assembly.
2. Remove the BTR Assembly by pulling the ends of BTR Assembly shaft while pressing
against the Transportation Chute Assembly .
NOTE: Do not remove the Transportation Chute Assembly bearings and springs
when you remove the BTR Assembly.
CAUTION: Do not touch the BTR surface or the Transportation Chute Assembly
Eliminator. After you have removed the BTR Assembly, cover it so it
will not get contaminated or damaged.
Replacement
1. Remove the Transportation Chute Assembly.
2. Align the BTR Assembly shaft (with the gear to the left side) with the Transportation Chute
Assembly bearing.
3. Press the right end of the BTR Assembly shaft into the right bearing on the Transportation
Chute Assembly. It will snap into place.
4. Place the blade of a small screwdriver at the bottom of the left bearing spring. This will stop
downward travel of the bearing when you are installing the BTR Assembly .
5. Press the left end of the BTR Assembly shaft into the left bearing on the Transportation
Chute Assembly. It will snap into place.
6. Reinstall the Transportation Chute Assembly.