Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-13
RRP 3.6 Front Transport Assembly
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove the Top Cover Assembly (RRP 1.2).
3. Remove the Left Cover (RRP 1.3).
4. Remove the Right Cover (RRP 1.4).
5. Remove the Fuser Assembly (RRP 4.1).
6. Remove the Gear Double L (RRP 3.2).
7. Remove the Gear Double R (RRP 3.3).
8. Remove the Lower Chute Assembly (RRP 3.4).
9. Remove the Link Assembly (RRP 3.1) .
10. Remove the Earth Plate Assembly (RRP 6.4).
11. Use a screwdriver to pry off the Cable Cap securing the wire harness running next to the Link
Assembly .
12. Hold the Front Transport Assembly while you slowly slide the Left and Right Pivot Shafts out.
13. Remove the Front Transport Assembly.
Replacement
1. Position the Front Transport Assembly so the pivot holes align.
2. Reinstall the Left and Right Pivot Shafts.
NOTE: Make sure the Pivot Shaft bearings are squarely seated in their slots.
3. Reinstall the Cable Cap.
NOTE: Make sure the wiring harness doesn't interfere with the Link Assembly.
4. Reinstall the Earth Plate Assembly.
5. Reinstall the Link Assembly.
6. Reinstall the Lower Chute Assembly.
7. Reinstall the Gear Double R.
8. Reinstall the Gear Double L.
9. Reinstall the Fuser Assembly.
10. Reinstall the Right Cover.
11. Reinstall the Left Cover.
12. Reinstall the Top Cover Assembly.
13. Close the Rear Cover.