Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-9
RRP 3.4 Lower Chute Assembly
Removal
1. Open the Front Transport Assembly.
2. Remove the Gear Double L (RRP 3.2).
3. Remove the Gear Double R (RRP 3.3).
4. Push the Lower Chute Assembly back, while pressing the Bottom Plate Assembly against the
Pick–Up Roll Assembly. This will expose the E–Rings securing the left and right Pivot Shafts.
5. Remove the E–Rings .
6. Pull both Pivot Shafts out about 25mm and remove the Lower Chute Assembly.
NOTE: Do not pull the Pivot Shafts completely out of the Front Transport Assembly
and the Gear Front Cover.
Replacement
1. Position the Lower Chute Assembly next to the Pivot Shafts.
2. Press the shafts all the way into the holes in the Lower Chute Assembly.
3. Reinstall the E–Ring in the second notch from the end of the left Shaft.
4. Reinstall the E–Ring in the first notch from the end of the right Shaft.
5. Replace both the Gear Double L and the Gear Double R.